Wireless Settings Page - AMX NXT-CV10 Operation/Reference Manual

Firmware Pages and Descriptions
If the calibration was improperly set and you cannot return to the Calibration
page (through the panel's firmware); you can access this firmware page via
G4 WebControl where you can navigate to the Protected Setup page and press the
Calibrate button through your VNC window.
This action causes the panel to go to the Calibration page seen above, where you
can physically recalibrate the actual touch panel again using the above procedures.

Wireless Settings Page

The Wireless Settings page (FIG. 103) sets the communication parameters for the installed wireless CF card
(either 802.11b/g). This information includes its corresponding IP communication parameters, wireless
communication settings, and read the device number assigned to the Modero panel. Both panels can use
802.11b/g for wireless communication.
Once the panel has been updated with the latest Modero firmware, some encryption and security features may/
may not be supported depending on the type of wireless card being used.
FIG. 102 Wireless Settings page (showing how each card supports its own security features)
Wireless Security Support
802.11b Wi-Fi CF card:
802.11g Wi-Fi CF card:
Refer to the Configuring a Wireless Connection section on page 57 for more detailed information of setting up
the Modero panel for wireless network access.
106
802.11b wireless card
• Open (Clear Text)
• Static WEP (64-bit and 128-bit key lengths)
Note: The WAP Site survey feature is disabled and is only supported by the
newer 802.11g card.
• Open (Clear Text)
• Static WEP (64-bit and 128-bit key lengths)
• WPA-PSK
• EAP security (with and without certificates)
• WAP SIte Survey
802.11g wireless card
10" Modero Touch Panels