System & Panel Options Page - AMX MVP-9000i-GB Instruction Manual

System & Panel Options page
Touch the Options button at the bottom of the Protected Setup page to open the System & Panel Options page (FIG. 66).
Protected Setup Navigation Buttons
FIG. 66
System & Panel Options Page
Back:
WiFi/Wired icon:
Connection Status
icon:
Panel Options:
Front Btn Access
Page Tracking:
Function Show:
Telnet:
Table Dock Latch: Enables and disables the docking latch on the Table Docking Station (page 21). If User Access is Enabled in the
Security:
Orientation:
System Options:
Reset Settings:
Install Firmware:
Undock Panel:
Remove Pages:
Install Pages:
USB Ready:
MVP-9000i - Instruction Manual
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is Wireless
(image of a radio antenna) or Wired (image of three networked computers).
The icon in the upper-right corner of each Protected Setup page provides a constant visual indication of current
connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
Enables or disables access to the Setup pages by holding the bottom left capacitive touch button and the bottom of
the directional pad. When set to Off, the Setup pages may only be accessed through the Reset button (FIG. 1)
Enables or disables the G4 page tracking feature that sends page flips to the Master via strings.
When the Function Show feature is displayed, the Channel Port and Code will appear in yellow, the Address Port and
Code in green, and the Level Port and Channel Code in purple.
Controls access via Telnet.
Passwords page (page 73), this switch will be disabled
Displays one of three security settings: Standard, Secure, and DoD. Pressing this button opens a popup window
allowing changes to the Security Profile.
Note: Refer to the Security Settings section on page 57 for very important information on using this feature.
Selects the orientation by which the panel pages are presented: 0° - Landscape, 90° - Portrait, and 270° - Portrait.
Deletes all of the current configuration parameters on the panel (including IP Addresses, Device Number
assignments, Passwords, and other presets). This option invokes a Confirmation dialog, prompting you to confirm
your selection before resetting the panel.
This button allows you to revert the current firmware to factory default, revert to the previously installed firmware
version, or to install firmware from a properly formatted USB thumb drive or microSD card.
Releases the panel from the Table Docking Station (page 21) or the Wall Docking Station (page 23).
Removes all TPD4 touch panel pages currently on the panel, including the pre-installed AMX Demo pages. This
option invokes a Confirmation dialog, prompting you to confirm your selection before removing the panel pages.
Note that the YES button on the Confirmation dialog is disabled for 5 seconds as additional protection against
accidentally resetting the panel or removing the panel pages.
Allows uploading of touch panel pages via USB thumb drive or microSD card. If the panel is not connected to a
thumb drive or microSD card, this button will be blacked out.
Notes that the panel is ready to accept files via a USB device.
Protected Setup Pages
56