Initial Status Settings - Sharp MX-3050N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS
High Quality Scan from Document Feeder (B/W)
The resolution for copying in black and white using the automatic document feeder can be changed from 600 x 400 dpi
to 600 x 600 dpi (high quality mode).
When high quality mode is used, fine print and thin lines are reproduced with greater clarity, however, the scanning speed
is slower.
When high quality mode is not selected, the following conditions must be satisfied in order to scan at 600 x 400 dpi and attain
the fastest speed.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the ratio.
• Do not copy in black and white with the [Color Start] key.
Quick Scan from Document Glass (B/W)
The resolution for copying in black and white using the document glass can be changed from 600 x 600 dpi to 600 x 400
dpi (high speed mode).
When high speed mode is selected, the first copy time is quicker, however, the copy image is not as clear.
When high quality mode is not selected, the following conditions must be satisfied in order to scan at 600 x 400 dpi and attain
the fastest speed.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the ratio.
• Do not copy in black and white with the [Color Start] key.
Auto Clear Before Copy Execution Also
Enables the Auto Clear function during copy even when a copy job is not completed. This protects the machine from
being held due to the incomplete copy job.

Initial Status Settings

The following settings are related to copying.
Initial Status Settings selected with these settings apply to all functions of the machine (not just the copy function).
The copier settings are reset to the initial state when the [Power] button is turned on, when the [CA] key is tapped, or
when the auto clear interval has elapsed. These settings are used to change the default settings for copy mode.
The following settings can be changed:
Item
Color Mode
Image Orientation
Paper Tray
Exposure Type
Copy Ratio
2-Sided Copy
Original Binding
Output Binding
Output
Configure default color mode settings.
Specify the original orientation.
Specify the paper tray that is selected by default.
Configure default exposure mode settings.
Specify the copy ratio that is selected by default.
Configure the 2-sided mode settings that are selected by default.
If this setting is used to change the default setting for the duplex function to any setting
other than "1-Side to 1-Side" and the duplex function or automatic document feeder fails or
is disabled, the setting will revert to "1-Side to 1-Side".
Set the original binding in 2-Sided copy.
Set the output binding in 2-Sided copy.
Set the print output method and output tray that are selected by default.
7-81
Description