Anti-Theft Systems - Mercedes-Benz S-Class 2011 Operator's Manual

Table of Contents

Advertisement

In order to maintain an appropriate distance
from the vehicle in front and thus prevent a
collision, you must apply the brakes yourself.
At speeds up to approximately
40 mph (70 km/h), PRE-SAFE
also detect stationary obstacles, for example
stopped or parked vehicles.
G
Warning!
If you do not receive visual or acoustic
warning signals, the PRE-SAFE
not have recognized the collision risk
R
have been deactivated
R
be malfunctioning
R
Apply the brakes yourself to avoid a collision.
X
To activate/deactivate: activate or
deactivate PRE-SAFE
Y
board computer (
After activation, the Ä symbol is
displayed on the left in the instrument
cluster.
®
For PRE-SAFE
Brake to assist you when
driving, the radar sensor system must be
switched on and operational.
®
PRE-SAFE
Brake does not always detect
complex traffic situations properly. You can
terminate the braking action of PRE-SAFE
Brake in a non-critical driving situation at any
time if:
an acoustic and visual warning occurs.
R
the vehicle brakes.
R
To stop the braking action, you can either
depress the accelerator pedal further,
activate kickdown or release the brake pedal.
The braking action of PRE-SAFE
ended automatically if:
you maneuver to avoid the obstacle.
R
your speed drops below approximately
R
9 mph (15 km/h).
there is no longer an obstacle detected in
R
front of your vehicle.
there is no longer any danger of a collision.
R
®
Brake may
®
Brake may
®
Brake in the on-
page 376).
®
®
Brake is

Anti-theft systems

Following a collision or collision-related
damage to the front end of the vehicle, have
the configuration and operation of the radar
sensors checked. Choose a qualified
specialist workshop which has the necessary
specialist knowledge and tools for the work
required. Mercedes-Benz recommends that
you use an authorized Mercedes-Benz Center
for this purpose.
Anti-theft systems
Immobilizer
The immobilizer prevents your vehicle from
being started without the correct key.
When leaving the vehicle, always take the
SmartKey with you and lock the vehicle. The
engine can be started by anyone with a valid
key that is left inside the vehicle.
X
To activate with the SmartKey: remove
the SmartKey from the ignition lock.
X
To activate with KEYLESS-GO: switch the
ignition off and open the driver's door.
X
To deactivate: switch on the ignition.
i
The immobilizer is always deactivated
when you start the engine.
ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the
alarm system is armed and you open:
a door
R
the vehicle with the mechanical key
R
the trunk lid
R
the hood
R
The alarm is not switched off, even if you
close the open door that has triggered it, for
example.
73
Z

Advertisement

Table of Contents
loading

Table of Contents