Procedure 6.7 - Replacing The Line Cord - Precor C932i Service Manual

Procedure 6.7 - Replacing the Line Cord

1. Set the treadmill circuit breaker in the "off" position and unplug the treadmill's line cord from
the A.C. outlet.
2. Remove the treadmill's hood.
1. Remove the two screws that fastens the A.C. input panel to the frame,. See Diagram 6.4.
2. Lift the A.C. input panel from the frame and rotate it to expose the A.C. line cord clamp
screws. See Diagram 6.5.
3. Remove the hardware that retains the A.C. line cord clamp and remove the clamp.
4. Disconnect the A.C. line cord from the input module.
5. Feed the end of the replacement A.C. line cord that mates with the input module through its
hole in the frame and firmly insert it into the input module.
6. Set the A.C. line cord clamp in its mounting position and fasten it with the hardware
removed in step 3.
7. Set the input panel in its mounting position and fasten it with the hardware removed in step
3.
8. Check treadmill operation per Section 3.
C932i, C946i Treadmill
Page 44