Sym RV 250i Service Manual page 113

5. Removal & Installation of Engine
Remove AC. generator and crankshaft position sensor
coupler.
Remove start motor wire from the start relay.
Remove O2 sensor wire coupler.
Remove fuel pump relay wire coupler.
Start engine for the pipeline to be exhausted within the
residual pressure, the engine flameout, relaxing fuel
tube folder, open for fuel tube.
Caution
Demolition for the pipeline, will be required for
●
residual pressure in the pipeline to divest, or use
the folder surrounds the tubing to prevent petrol
splash.
5-4
To this chapter contents
AC. generator and crankshaft
position sensor coupler
Start motor wire
O2 sensor coupler
O2 sensor coupler
Fuel pump relay coupler
Fuel tube