Child Lock; Temperature Limiter; Pan Detection - CDA HCN510 Manual For Installation, Use And Maintenance

Childlock
The hob is equipped with a childlock to lock the controls. This can be used when the hob is off or during cooking.
To switch on the childlock
Touch the key for approximately two seconds until the LED above the childlock key illuminates and the hob beeps to confirm
the childlock is switched on.
To turn off the childlock
Touch the key for approximately two seconds until the LED above the childlock key switches off and the hob beeps to confirm
the childlock is switched on.
Use of the childlock when the hob is off
The childlock LED is illuminated to show the childlock is on.
Use of the childlock when the hob is in use
The childlock LED is illuminated to confirm that childlock is switched on and no adjustments can be made to any of the zones or
the timer.
It is possible to switch off the hob using the
Please note:
The childlock is switched on automatically when the hob is first connected to the power. You must switch off the childlock to be
able to configure and use the hob.
Residual heat indicators
The hob is equipped with residual heat indicators to warn when any of the zones are still hot to the touch after cooking. An H will
show in the relevant zone display after cooking until the zone is at a safe temperature to touch.
In the event of a power cut, the residual heat indictors will illuminate after the power supply is restored. However, when there is
no power supply to the hob the residual heat indicators will not work, so extra care must be taken.
Please note:
You should avoid touching the zones when the hob is in use, or when an H is showing on the zone display.
Small object safety
Anything left on the control panel (e.g. cutlery or towels) will cause the hob to switch off automatically and there will be a beep
every ten seconds until the obstruction is removed.

Temperature limiter

The hob is equipped with a temperature limiting sensor that will switch off the zone and show C alternating with the power level
in the zone display until the hob temperature is within the limits preset.

Pan detection

The hob is equipped with a sensor that will advise when the pan is removed from the zone, or is unsuitable for use on induction
hobs. The zone display will show U alternating with the power level until a suitable pan is placed on the zone. The zone will
switch off after approximately one minute if no suitable pan is placed on the zone.
6
key when the childlock is on for safety reasons.