Dremel 3D20 Quick Start Manual

Read the Dremel 3D20 manual and
these instructions. Failure to comply
with the warnings and instructions may result in fire,
equipment damage, property damage, or personal
Always unplug Dremel 3D20 from its power before per-
forming any service procedures. Failure to do so may
re-sult in personal injury and equipment damage.
Use only Dremel approved materials and components.
Use of object materials, or 3D objects other than Dremel
approved object materials
components may void warranty.
Repairs on the Dremel 3D20 may require the use of special
tools (pulling devices and bearing press). Authorized repair
centers have trained repair technicians and equipment
necessary to perform these repairs.
Do not touch the extruder tip or heated build platform during Dremel 3D20 operation or until it
has cooled down to at least 60oC (140oF). Contact with the extruder tip or build platform during or
after operation before tip and build platform has cooled may result in personal injury.
Please click here for Video Tutorial
Tools Required:
• Scissors
• 2,5 mm Allen key
• Needle Nose Pliers
Step 1: Remove the top cover
Unclogging the 3D20
injury.
and genuine Dremel
SERVICE INSTRUCTIONS
For the location of the repair center near you, look on
our web site at www.Dremel3D.com and follow the link
for 'Support'.
Step 2: Unload filament from the extruder.
Step 3: Power off then unplug the power
cord from the Dremel 3D Idea Builder.