Best Practices; Operating Environment - Dremel 3D20 Quick Start Manual

4. Your Dremel 3D20 will align the extruder with the build
platform and will begin heating the extruder.
5. Once the build temperature is reached, your model will
begin to build.
4
Getting Ready to Build
6. Touch screen will display "Object Finished" . Tap the check
box to confirm. Wait until the touch screen indicates that
the extruder temperature is "COOL" .
OBSERVE ALL PROVIDED WARNINGS AND SAFETY
WARNING WARNING
INSTRUCTIONS WHEN USING THE DREMEL 3D20.
FAILURE TO DO SO MAY RESULT IN FIRE, EQUIPMENT DAMAGE,
REMOVING YOUR OBJECT FROM THE BUILD
PROPERTY DAMAGE OR PERSONAL INJURY.
PLATFORM
FILAMENT INSTALLATION
7. Wait for the extruder to cool before removing your object.
8. With the object still attached, remove build platform from
1. Ensure the power switch is in the off position, remove the lid
the build area.
and remove the build platform.
9. Use your hand to peel your object from the build platform. If
2. Place filament spool onto spool holder with spool being fed from
needed, gently use the object removal tool to remove object
the bottom towards the back of the Dremel 3D20. Insert spool
from build platform.
lock into spool holder and rotate 90 degrees to lock in place.
3. Thread filament through filament guide tube.
4. Insert the filament coming from the filament guide tube into
the extruder intake (top).
5. Adhere build tape over the build platform.
6. Install the build platform using the build platform clip
to secure.
7
Best Practices & Resources
7. Plug power cord into outlet and turn on power switch.
8. Tap "Tools" on your Dremel 3D20's touch screen, then tap
"Filament" , then tap "Load Filament" and wait for the extruder

BEST PRACTICES

to heat.
1. ALWAYS USE BUILD TAPE.
9. Once heated, filament will drawn through the extruder. Allow
filament to exit the extruder for 10 seconds before tapping the
2. Ensure your build platform is level before every object.
return arrow to complete.
3. Ensure spool is installed properly and can rotate freely.
4. When loading filament, allow Dremel 3D20 to extrude until
material is consistent with the installed filament color.
5. It is important to stay near your Dremel 3D20 during
operation and watch the Dremel 3D20 begin building
objects.
6. Use object removal tool gently to avoid damaging the build
platform or object.
7. Remove the build platform before removing the object.
1
3
LIFT
1
9
Filament
Guide
3

OPERATING ENVIRONMENT

Room Temperature: 16-29° C (60 - 85° F)
Level workspace
5
Dry workspace environment
SIDE 1
19.1" (485mm)
3D20 RESOURCES
2
5
2
4
8 WALL
8" (203mm)
13.2" (335mm)
PRESS COLORS
8" (203mm)