Troubleshooting - Uniden EZI33XLT Owner's Manual

TROUBLESHOOTING

If your EZI33XLT is not performing properly, try the following
steps.
Problem
Improper
reception.
Scan won't
stop.
Scan won't
start.
UNIDEN EZI33XLT
UB366AV_EZI33XLT_0119.indd 23 UB366AV_EZI33XLT_0119.indd 23
Possible Cause
The scanner's
antenna might
need to be
adjusted.
The squelch
might need to be
adjusted.
The antenna
might need to be
adjusted.
The channel's
frequency might
not be stored in
favourites.
The channel might
not be active.
You must be service
or favourites mode.
The squelch
might need to be
adjusted.
The antenna
might need to be
adjusted.
Suggestion
Check the antenna connection
or move or reposition the
antenna.
Move the scanner.
You might be in a remote
area that could require an
optional multi-band antenna.
Check with your dealer or local
electronics store.
Adjust the squelch threshold.
See "To adjust the squelch" on
page 17.
Check the antenna connection.
Make sure the channel's
frequency is stored in the
scanner's favourites bank.
Wait for a transmission on the
channel.
Press (Srvc/Fav). If
is showing press (Hold) to
resume.
Adjust the squelch threshold.
See "To adjust the squelch" on
page 17.
Check the antenna connection.
23
HOLD
Scanner
2012/01/19 20:58:20 2012/01/19 20:58:20