Select Step Frequency; Lockout Preprogram Frequency; Lockout Favourite Channel - Uniden EZI33XLT Owner's Manual

OPERATION

SELECT STEP FREQUENCY

You can change the steps of VHF-Low, FM, Aircraft, VHF-High
and UHF bank.
1.
2.
3.
4.

LOCKOUT PREPROGRAM FREQUENCY

You can skip up to 40 specifi ed frequencies during a Service scan.
This lets you avoid unwanted frequencies in Service Scan Mode.
To skip a frequency:
1.
To cancel skip for a single frequency:
1.
To cancel all skip frequencies:
1.

LOCKOUT FAVOURITE CHANNEL

you can increase the scanning speed by locking out channels
that have a continuous transmission for all the channels in
favourite channel memory.
To lock out a channel:
1.
Note: You can still manually select locked-out channels.
To remove the lockout from a channel:
1.
UNIDEN EZI33XLT
UB366AV_EZI33XLT_0119.indd 20 UB366AV_EZI33XLT_0119.indd 20
Press (Srvc) until a bank you want to change appears.
Press (Stp) until a step mode appears.
Use the / to select steps from Auto / 5.0 / 6.25 / 10.0 /
12.5 kHz ( The Step for Aircraft bank is 8.33 or 12.5 kHz.)
Press (Clr) or (Stp) or wait for 2 seconds to return to the
mode you were in.
Press (L/O) when the scanner stops on the frequency in
Service Scan Mode or when you have selected frequency
manually in Service scan hold mode. L/O appears.
Manually select the frequency, then (L/O). L/O disappears.
Press (Hold) to stop scanning in Service scan hold mode,
then press & hold (L/O). A confi rmation tone sounds.
Manually select the channel, then press (L/O). L/O appears.
Manually select the channel, then press (L/O). L/O disappears.
20
Scanner
2012/01/19 20:58:20 2012/01/19 20:58:20