Troubleshooting - Uniden BC350C Manual

If your BC350C is not performing properly, try the steps listed
below.
PROBLEM
Scanner won't work
Improper reception
Weather scan won't
work
Scan won't stop

Troubleshooting

* Applies to mobile installation only
•
Check the connections at both ends of
the AC Adapter.
•
Turn on the wall switch of your room.
You could be using an outlet controlled
by the wall switch. Move the AC
Adapter to another wall outlet.
•
Check the connections at both ends of
the DC cord or cigarette lighter cord.
•
Check to see if the fuse is blown.
If the fuse is blown.
•
Make sure the ignition key in your
vehicle is at the Accessory position.
* Make sure the power switch is turned
on.
•
Check the antenna and its connection.
•
Move the scanner.
•
You may be in a fringe area. This may
require an optional multi-band antenna.
Check with your dealer or local
electronics store.
•
Adjust the Squelch Control, 2. Check
the Antenna Connection.
•
Check to see if many of the channels
are loced out. If so. the scanner has
less chanse of finding an active
channelsl.
•
Review each channel's frequency to
see if it is still stored in memory and is
correct.
•
Check and adjust Squelch
(see "Adjusting the Squelch").
•
Check the antenna connection.
•
Check to see if all channels are locked
out.
•
It is possible that none of the
programmed frequencies are active at
the time. Try the band search.
SOLUTION
30