Connecting An Optional Antenna; Connecting The Earphone - Uniden EZI33XLT Owner's Manual

SETTING UP YOUR SCANNER
To attach the supplied fl exible antenna to the connector on
the top of your scanner, align the slots around the antenna's
connector with the tabs on the scanner's BNC connector.
Then slide the antenna's connector down over the scanner's
connector and rotate the antenna connector's outer ring
clockwise until it locks into place.

CONNECTING AN OPTIONAL ANTENNA

The scanner's BNC connector makes it easy to connect a variety of
optional antennas, including an external mobile antenna or outdoor
base station antenna.
NOTE: Always use 50-ohm, RG-58, or RG-8, coaxial cable to
connect an outdoor antenna. If the antenna is over 15 metres
from the scanner, use RG-8 lowloss dielectric coaxial cable. You
can get a BNC adapter at your local electronics store.

CONNECTING THE EARPHONE

For private listening, you can plug the 3.5mm miniplug
earphone into the headphone jack on top of your scanner.
This automatically disconnects the internal speaker.
WARNING!
If you connect an external speaker to the scanner's headphone
jack, never connect the audio output line to a power supply
and ground. This might damage the scanner.
UNIDEN EZI33XLT
UB366AV_EZI33XLT_0119.indd 11 UB366AV_EZI33XLT_0119.indd 11
11
Scanner
2012/01/19 20:58:19 2012/01/19 20:58:19