Troubleshooting - Uniden EZI30XLT Owner's Manual

TROUBLESHOOTING

If your EZI30XLT is not performing properly, try the following
steps.
Problem Possible Cause
Improper The scanner's
reception. antenna might
need to be
adjusted.
Scan The squelch
won't might need to be
stop. adjusted.
The antenna
might need to be
adjusted.
The channel's
frequency might
not be stored in
favourites.
The channel might
not be active.
Scan You must be
won't service or
start. favourites mode.
The squelch
might need to be
adjusted.
The antenna
might need to be
adjusted.
UNIDEN EZI30XLT
Suggestion
Check the antenna
connection or move or
reposition the antenna.
Move the scanner.
You might be in a remote area
that could require an optional
multi-band antenna. Check
with your dealer or local
electronics store.
Adjust the squelch threshold.
See "To adjust the squelch" on
page 17.
Check the antenna
connection.
Make sure the channel's
frequency is stored in the
scanner's favourites bank.
Wait for a transmission on
the channel.
Press (Srvc/Fav). If
is showing press (Hold) to
resume.
Adjust the squelch threshold.
See "To adjust the squelch" on
page 17.
Check the antenna
connection.
22
HOLD
Scanner