Adjusting The Volume - Canon Elura 90 Instruction Manual

Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via /-;;-
built-in speaker. The speaker does not sound when you close the LCD panel. Use
~
headphones when using the viewfinder.
SET dial
-
;;~~=~~~--- Speaker
The headphones terminal also serves as AV terminal. Headphones can only be used
when"
0"
is displayed on the screen. If not, change the setting following the procedure
below.
I
~~~)
I
VCR SETUP
H
AV/PHONES \) .. AV
Open the menu and select [VCR SETUP]. Select [AV/PHONES 0], set it to
[PHONES 0] and close the menu.
n
0 The speaker does not sound when"
0"
is displayed.
n
0 Do not connect headphones unless"
0"
is displayed as it produces noise.
I
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the
volume again.
35