Canon Elura 90 Instruction Manual page 173

I
Installing the Digital Video Software
o
Be sure to install the Digital Video Software before connecting the
camcorder to the computer.
o
Users of Windows 2000 or Windows XP must first log in as an Administrator
to install programs.
Windows XP Users:
Your digital video camcorder is equipped with the standard Picture Transfer
Protocol (PTP). This protocol enables you to download images by simply
connecting the camcorder to a computer with the USB cable (the software such
as the [Scanner and Camera Wizard] starts automatically).
However, please note that there are several limitations to downloading images
with this method. To avoid these problems, install ZoomBrowser EX to
download images.
- It may take a few minutes, after connecting the camcorder, until you can
download images.
- Images protected on the camcorder may lose this setting once they are
downloaded to the computer.
1
Check a camcorder is not connected to the computer.
While a camcorder is connected to the computer, the software cannot be
installed normally. If a camcorder is connected, detach the USB cable from the
computer.
2
Close any programs that are running.
3
Set the DIGITAL VIDEO SOLUTION DISK in the computer's
CD-ROM drive.
• The installer panel opens automatically.
• If the installer panel does not open automatically, use the folloWing procedures
to display it.
- Windows 98/Windows Me/Windows 2000:
1) Double-click the [My Computer] icon.
2) Right-click the CD-ROM icon and select [Open] from the displayed
menu.
3) Double-click the [Setup.exe] icon.
- Windows XP:
1) Select [My Computer] from the [start] menu.
2) Right-click the CD-ROM icon and select [Open] from the displayed
menu.
3) Double-click the [Setup.exe] icon.
Depending on the setting of your computer, the file extension" .exe" may not
appear.