Using Multiples Handsets; Registering Handsets - Siemens Gigaset S675 IP Manual

Using multiples handsets

Using multiples handsets

Registering handsets

You can register up to six handsets to your base station.
You can register your Gigaset S67H handset on up to four base stations.
When you register a new Gigaset handset, the base station transfers the
Gigaset.net entry for the Gigaset.net directory to its local directory to enable
you to use the Gigaset.net directory on your new handset.
Prerequisite: The handset can send and receive directory entries. See the
handset's user guide for further information.
Successful registration is acknowledged with the message
received
Please note
u
If a number of handsets are registered on your base station, you can simul-
taneously make two calls via the Internet and one via the fixed line network.
Up to two additional internal connections are also possible.
u
Selecting the connection via the Talk key (
GAP handsets. This means that if you enter a number without a line suffix
and without defining a dialing plan for the phone number, it is dialed via
Default Line
u
After registration, all the phone numbers for the phone are assigned to the
handset as receive numbers. It will use the fixed line network number and
the first VoIP number as send numbers. For information on how to change
the assignments,
Registering another Gigaset S67H handset on the Gigaset S675 IP
Before you can use your handset, you must register it to the base station.
You must initiate handset registration on the handset and on the base station.
If the handset has been registered successfully, the handset returns to idle sta-
tus. The handset's internal number is shown in the display e.g.
repeat the procedure. Registration can take up to one minute.
¤
Select v
¤
Enter the system PIN of the base station (the default is 0000) and press
The display shows e.g.
¤
Within the next 60 seconds press and hold (for approx. 3 seconds) the Reg-
istration/Paging key (
The handset is assigned the lowest available internal number (1-6). If a number
of handsets are registered on the base station, the internal number appears in
the display after registration, e.g.
was assigned to the handset.
114
for this reason.
£
( Page 135).
£
Page
¢ ¢
Ð
Handset
Base 1
£
Page
£
Page
169.
¢
Register H/Set
and flashes.
2) on the base station.
2. This means that the internal number 2
INT
Data Transfer x entries
46) is not supported on
1. If not,
Int
on the handset.
.
§OK§