Fluke 8845A Manual page 107

Table 33. Execution Error Codes and Descriptions (cont.)
Error Code Error Text
-230 Data stale
-242 Date timeout
-243 Second function invalid
-318 Can't save MAC
-319 Can't save LAN
configuration
-320 Can't save non-volatile
configuration
-330 Self-test failed
-350 Too many errors
-410 Query interrupted
-420 Query
UNTERMINATED
-430 Query DEADLOCKED
-440 Query
UNTERMINATED after
indefinite response
-501 RTC Time
-502 RTC Data
31 mA AC/DC selected
while REAR inputs
selected.
Description
A FETCh? command was received but internal reading
memory was empty. The reading retrieved may be invalid.
Timed out while taking data.
Secondary function is not enabled.
Could not save MAC address.
Could not save network configuration.
Could not save non-volatile configuration.
The Meter's complete self-test failed from the remote interface
(*TST? command). In addition to this error, more specific self-
test errors are also reported.
The error queue is full because more than 16 errors have
occurred. No additional errors are stored until you remove
errors from the queue. The error queue is cleared when power
has been off, or after a *CLS (clear status) command has been
executed.
A command was received which sends data to the output
buffer, but the output buffer contained data from a previous
command (the previous data is not overwritten). The output
buffer is cleared when power has been off, or after a *RST
(reset) command has been executed.
The Meter was addressed to talk (i.e., to send data over the
interface) but a command has not been received which sends
data to the output buffer. For example, a CONFigure command
(which does not generate a response) may have been
executed, followed by an attempt to read data from the remote
interface.
A command was received that generated too much data to fit
in the output buffer, and the input buffer is also full. Command
execution continues but all data is lost.
The *IDN? command must be the last query command within a
command string. Example: *IDN?;:SYST:VERS?
Error setting the RTC/System time.
Error setting the RTC/System date.
8842A emulation error. The Front/Rear input switch was set to
REAR while ac/dc current was selected via a remote command
or ac/dc current was selected and the Front/Rear switch was
switched to REAR.
Remote Operation
Error Codes
97