Solid-State Drives (M.2) - HP ZBook 17 G3 Maintenance And Service Manual

Solid-state drives (M.2)

Description
1 TB, Z Turbo drive PCIe
512 GB, Z Turbo Drive, PCIe
256 GB, Z Turbo Drive, PCIe
256 GB, SATA-3, self-encrypting drive (SED), Opal 2
512 GB, SATA-3, self-encrypting drive (SED), Opal 2
Before removing the SSD, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Disconnect the battery (see
6. If you are removing the secondary SSD, remove the secondary hard drive (see
NOTE:
Remove the SSD:
1. Remove the Phillips screw (1) that secures the solid-state drive to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Service door on page
Battery on page
The secondary SSD is only available if a primary SSD is installed.
33).
34).
Component replacement procedures
Spare part number
848366-001
848364-001
848363-001
848365-001
848367-001
Hard drive on page 35).
39