Display Led Board - HP ZBook 17 G3 Maintenance And Service Manual

▲ Remove the two screws (1) securing the board to the system board, and then remove the discrete
graphics board (2).
Reverse this procedure to install the discrete graphics board.

Display LED board

Description
Display LED board
Before removing the display LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the service door (see
6. Remove the battery (see
7. Remove the secondary hard drive (see
8. Remove the secondary SSD (see
Remove the display LED board:
1. Open the ZIF connector (1) on the system board to release the display LED board ribbon cable, and then
release the ribbon cable (2) from the adhesive securing it to the computer.
Service door on page
Service door on page
Battery on page 34).
Hard drive on page
Solid-state drives (M.2) on page
33).
33).
35).
39).
Component replacement procedures
Spare part number
848374-001
57