Attaching The Embroidery Hoop To The Machine; Thread Holder - ELNA 9600 "Haute Couture" Instruction Manual

1
2
3
5
6

Attaching the Embroidery Hoop to the Machine

Turn the attaching knob so it is parallel with the carriage
arm, and set the hoop on the carriage.
Attach the hoop by fitting the pins into the carriage
holes.
1 Attaching Knob
2 Carriage Holes
3 Pins
Turn the attaching knob clockwise to secure the hoop
CAUTIONS:
Do not attach the hoop unless the carriage arm is in the
setting position.
Always provide sufficient clearance for the embroidery
carriage behind your machine before starting
embroidery.
Never try to move the carriage with hand or touch the
carriage while it is moving.
Make sure to return the carriage to the stored position
before turning the power off.
NOTE:
Refer to page 91 for the instructions on hoop AQ.

Thread Holder

To avoid sewing on the needle thread, place the thread
end on the thread holder.
Pass the needle thread through the hole in the
embroidery foot and draw it up to the thread holder.
Hang the thread on the thread holder from the front to
back.
68