Automatic (Square) Buttonhole - ELNA 9600 "Haute Couture" Instruction Manual

Buttonholes(B)
Auto BH
5
2 3 4
1
AUTO
9 11
8 10 12
15 16 17 18 19
Step 1
Sew to length required,
then press " ".
Step 2
Sew up to start position,
then press " ".
Step 3
Machine stops when
BH is completed.
Restart for the same size.
Different size
R
6 7
13 14
20 21
R
R
R
38

Automatic (square) buttonhole

Select pattern B2.
Pull the button holder all the way out.
Mark the buttonhole position on the fabric. Insert the
fabric under the foot. Press the up/down needle button
twice. Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Insert the garment under the foot, and lower the needle
at the starting point.
Then lower the automatic buttonhole foot R.
NOTES:
You do not need to pull down the buttonhole lever.
If you wish to change the buttonhole width and stitch
density press the adjust key.
If you wish to sew a buttonhole longer than the size
permitted by the automatic buttonhole foot R, use satin
stitch foot F.
Step-1
Sew up the left side until the end of the buttonhole
mark. Then press the reverse button.
Step-2
Depress the foot control. The machine will automatically
tack and sew down the right side of the buttonhole.
Stop the machine when you are directly opposite the
starting point.
Press the reverse button.
Step-3
Keep the foot control depressed. The machine will
bartack, lock the stitches and automatically stop when
the buttonhole is completed.
To make the next buttonhole, position the fabric and
step down on the foot control.
To sew the next button hole in a different size press the
exit key . The machine will sew another
X
buttonhole identical to the first one each time you step
down on the foot control.
NOTE:
To cut the buttonhole opening, refer to the instructions
on the previous page.