Sanyo SAP–K181AHA–S Technical & Service Manual page 76

Air cleaning filter
(not provided)
NOTE
How to install the air
cleaning filter
NOTE
Cleaning the main unit and
remote control unit
Removing and remounting
the air intake grille
CAUTION
Washing the grille with
water
24
Care and Cleaning (continued)
The air cleaning filter removes dust and dirt from the air, and reduces
odors and smoke from tobacco.
The air clean filter is not provided with the air conditioner and must be
purchased separately.
Ask for the STK-F4B model when purchasing.
The air cleaning filter cannot remove harmful gases or vapors nor
ventilate air in the room. You must open doors or windows frequently
when you use gas or oil heating appliances. Otherwise there is a risk
of suffocation in extreme cases.
The air cleaning filter needs to
be installed behind the
anti-mold filter.
1. Remove the anti-mold filter.
2. To mount the STK-F4B, set
the air clean filter(sold
separately) at the mounting
position with the black side
facing the rear.
3. Reinstall the anti-mold filter,
and close the suction grill.
Dirty air clean filters cannot be
washed and reused. Purchase a
replacement filter at your local
dealer.
Wipe clean using a soft, dry cloth.
•
To remove stubborn dirt, moisten a cloth in warm water no hotter
•
than 40 °C, wring thoroughly, and then wipe.
The air intake grille can be removed in order to wash it with water.
•
With the air intake grille
•
open all the way, grip both
arms with your hands and
pull toward you to remove.
To remount, hold the air
intake grille roughly
horizontal and push it in
until the arm shafts fit into
the indentations in the main
unit, then fit the grille into
place.
When using a footstool or the like, be careful not to let it tip over.
Clean the grille gently using a soft sponge, or the like. Then wipe
•
away any remaining moisture.
Neutral detergent may be used to remove stubborn dirt. Then rinse
•
thoroughly with water and wipe away any remaining moisture.
Air clean filter
Air intake grille
Arm
OI-332-024EG