Sanyo SAP–K181AHA–S Technical & Service Manual page 75

Anti-Mold Filter
How to remove the
anti-mold filter
Cleaning
How to replace the
anti-mold filter
OI-332-023EG
Care and Cleaning (continued)
The anti-mold filter behind the air intake grille should be checked and
cleaned at least once every two weeks.
1. Grasp both ends of
the air intake grille
and pull it out and
up.
2. Push the anti-mold
filter up slightly, and
then pull it down.
Use a vacuum cleaner to remove light dust. If there is sticky dust on the
filter, wash the filter in lukewarm, soapy water, rinse it in clean water,
and dry it.
1. With the ''FRONT''
mark facing you,
slide the anti-mold
filter up into the unit
and then lower the
handle into the
groove on the unit.
2. After installing the
anti-mold filter, press
the locations marked
by the arrows ( )
and close the air
intake grille.
Air intake grille
Anti-mold filter
Air intake grille
Anti-mold filter
Insert into the groove on the unit.
23