Adjusting The Fan Speed - Sanyo SAP–K181AHA–S Technical & Service Manual

NOTE
3. Adjusting the
Fan Speed
A. Automatic
Cooling and DRY mode:
Heating mode:
NOTE
B. Manual
14
Operation with the Remote Control Unit (continued)
This appliance has a built-in 3-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the
unit will restart automatically after three minutes.
Simply set the FAN SPEED selector button to the
A microcomputer in the air conditioner automatically controls the fan
speed when the mode is selected. When the air conditioner starts
operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automati-
cally switches the fan speed to the most suitable level.
When difference between
room temperature and set
temperature is
2 °C and over
Between 2 °C and 1 °C
Below 1 °C
When difference between
room temperature and set
temperature is
2°C and over
Below 2°C
The above table assumes that the sensor on the remote control is
being used. If the sensor on the indoor unit is being used (the
indicator is on), actual operation may differ slightly from the operation
described in the table.
(Refer to "A/C SENSOR button" on page 9.)
If you want to adjust fan speed manually during operation, just set the
FAN SPEED selector as desired. [
position.
FAN SPEED
High
Medium
Low
FAN SPEED
High
Medium
, , or ]
OI-332-014EG