Table of Contents
Advertisement
MBT-5003 L-Band Up/Down Converter System
Appendix A
Command
Arguments
Parameter
(Instruction
for Command
Type
Code and
or Response
Qualifier)
Serial Number
N/A
9 bytes
Remote
SPA=
4 bytes
Address
Set Statistics
SSI=
2 bytes
Interval
Software
N/A
variable length
Revision
Set RTC Time
TIM=
6 bytes
Description of Arguments
(Note that all arguments are ASCII numeric codes
to Query
Query only.
Used to query the unit 9-digit serial number. Unit returns its S/N in
the form xxxxxxxxx.
Example: SNO=176500143
Command or Query.
Set Physical Address-between 0001 to 9997.
Resolution 0001
Default Value: 0001
Example: <1/SPA=0412'cr'
>0001/SPA='cr''lf'
Note: 9998 and 9999 are reserved for the block converter A and B
if the base address is 9997.
Command or Query.
Sets the interval at which statistics are logged. Minimum resolution
is 10 minutes, maximum is 90 minutes in 10 minute intervals.
Default Value: 90
Example: <1/SSI=90'cr'
>0001/SSI='cr''lf'
Query only.
Unit returns the value of the internal software revision installed in
the unit, in the form :
Boot:x.y.z Bulk1:x.y.z Bulk2:x.y.z
-or-
Boot:x.y.zz Bulk1:x.y.zz Bulk2:x.y.zz
Command or Query.
A command in the form hhmmss, indicating the time from
midnight, where hh = hours, between 00 and 23; mm=minutes
between 00 and 59, and ss= seconds between 00 and 59
Example: <1/TIM=231259'cr'
>0001/TIM='cr''lf'
(time = 23 hours, 12 minutes and 59 seconds since midnight)
between 48 and 57)
A–16
Response to
Query
Command
(Instruction
(Target to
Code and
controller)
qualifier)
N/A
SNO?
SNO=xxxxxxxxx
(See Description of
Arguments)
SPA=
SPA?
SPA=xxxx
SPA?
(Same format as command
arguments)
SSI=
SSI?
SSI=xx
SSI?
(Same format as command
arguments)
N/A
SWR?
SWR=Boot:x.y.zz
Bulk1:x.y.zz Bulk2:x.y.zz
(See description
of arguments)
TIM =
TIM?
TIM=xxxxxx
TIM?
TIM *
(Same format as command
arguments)
Revision 1
MN-MBT5003
Response to query
(Target to controller)
Advertisement
Table of Contents
