2.
Use a thin, non-conductive tool to remove the RTC battery (1) from the socket on the system board.
Reverse this procedure to install the RTC battery on computer models. When installing the RTC battery, make
sure the "+" sign faces up.
Power connector
Description
For use with HP Pavilion 15 Notebook PC computer models
For use with HP Pavilion 17 Notebook PC computer models
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive.
6.
Remove the top cover from the base enclosure (see
7.
Remove the WLAN module (see
8.
Remove the system board (see
Remove the power connector cable:
NOTE:
The power connector cover was removed during the system board removal.
Battery on page
42),
WLAN module on page
System board on page
Base enclosure on page
62).
70).
Component replacement procedures
Spare part number
762507-001
763699-001
46).
83