Deck Rollers And Skids - Toro Groundsmaster 4100-D Service Manual

Deck Rollers and Skids

9
10
8
7
6
RIGHT
FRONT
1. Roller
2. Flange head screw
3. Roller shaft
4. Flange nut
Removal (Fig. 23)
1. Remove skids and rollers from deck using Figure 23
as a guide.
Cutting Deck
5
4
3
5. Lock nut
6. Roller
7. Cap screw
7
6
2
1
Figure 23
Installation (Fig. 23)
1. Install skids (item 9) to deck using Figure 23 as a
guide. Make sure to install skids in the same mounting
hole height position (lower or upper).
2. Install rollers (items 1 and 6) to deck using Figure 23
as a guide. When installing roller (item 6), install cap
screw with the threads orientated toward the centerline
of the deck. Install and tighten lock nut until roller will not
rotate, then loosen lock nut only enough to allow roller
to rotate freely. Make sure to install all deck rollers in the
same mounting hole height position (lower or upper).
Page 8 - - 24
5
5
6
8. Flange nut
9. Skid (RH shown)
10. Flange head screw
Groundsmaster 4100--D/4110--D
7