Adjustments; Wing Deck Position Switches - Toro Groundsmaster 4100-D Service Manual

Adjustments

Wing Deck Position Switches

Adjustment
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove switch cover from deck to allow access to
position switch that requires adjustment.
3. Raise and lower wing deck while monitoring the wing
deck latch and the position switch LED on cable end of
switch:
A. The position switch should open (switch LED is
not illuminated) when the wing deck link causes the
wing deck latch to disengage as wing deck is raised.
B. The position switch should close (switch LED is
illuminated) when the wing deck link causes the wing
deck latch to engage as wing deck is lowered.
4. If necessary, adjust switch location to allow correct
operation:
A. Loosen jam nuts on switch and adjust switch
location to allow proper switch operation.
B. After switch adjustment, torque jam nuts from
165 to 195 in- -lb (18.7 to 22.0 N- -m).
C. Make sure that position switch does not contact
bolt head on wing deck link when wing deck is fully
lowered.
5. After testing is complete, make sure that switch con-
nector is plugged into deck wire harness and switch cov-
er is secured to deck.
Groundsmaster 4100--D/4110--D
1. Switch cover
2. Position switch
3. Switch bracket
2
3
1. Position switch
2. Bolt head
Page 5 - - 19
3
4
5
1
2
Figure 13
4. Lock washer (2 used)
5. Jam nut (2 used)
1
Figure 14
3. Wing deck link
Electrical System