Toro Groundsmaster 4100-D Service Manual page 252

8. Install steering cylinder to axle assembly (see Steer-
ing Cylinder Installation in the Service and Repairs sec-
tion of Chapter 4 -- Hydraulic System).
9. Install hydraulic motor to axle assembly (see Rear
Axle Motor Installation in the Service and Repairs sec-
tion of Chapter 4 -- Hydraulic System).
10.Install wheels to rear axle.
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may re-
sult in personal injury.
11. Lower machine to ground. Torque wheel lug nuts
from 85 to 100 ft- -lb (115 to 135 N- -m).
12.Fill axle and input gearbox with SAE 85W--140
weight gear lube. Lubricant capacity is approximately 80
fl. oz. (2.37 liters) for the axle and 16 fl. oz. (0.47 liters)
for the gearbox.
13.Check rear wheel toe--in and adjust if necessary.
14.Check steering stop bolt adjustment. When the
steering cylinder is fully extended (right turn), a gap of
1/16 in. (1.6 mm) should exist between bevel gear case
casting and stop bolt on left axle case. Figure 15 shows
stop bolt location.
Axles, Planetaries and Brakes
1. Steering stop bolt
Page 6 - - 18
1
Figure 15
2. Bevel gear case (LH)
Groundsmaster 4100--D/4110--D
2