Adjusting The Mower Deck Anti-Scalp Rollers - Toro Groundsmaster 5900 Operator's Manual

Adjusting the Outer Skids
Mount the outer skids in the lower position when
operating at heights of cut greater than 51 mm (2
inches) and in the higher position when operating at
heights of cut lower than 51 mm (2 inches).
Note:
When the outer skids become worn, you can
switch them to the opposite sides of the mower by
flipping them over. This allows you to use the outer
skids longer before replacing them.
Adjust the outer skids
Important:
Torque the screw at the front of each
outer skid to 9 to 11 N·m (80 to 100 in-lb).
Figure 40
(Figure 40).
Adjusting the Mower Deck
Anti-Scalp Rollers
Mount the roller in the lower position when operating
at heights of cut greater than 51 mm (2 inches) and
in a higher position when operating at heights of cut
lower than 51 mm (2 inches).
Adjusting the Roller
1. Remove the roller shaft, screw, and nut securing
the roller to the deck bracket
1. Roller
2. Align the roller with the top holes and install the
shaft with the screw and nut
g031063
1. Roller
41
(Figure 41).
Figure 41
2. Roller shaft, screw, and
nut
(Figure 42).
Figure 42
2. Roller shaft, screw, and
nut
g033107
g033108