Toro Groundsmaster 4100-D Service Manual page 294

NOTE: Installation of clevis pins to deck and height--of--
cut chains is easier if deck is lifted slightly.
4. Install clevis pins and hairpins that secure the
height--of--cut chains to the rear of the cutting deck (Fig.
2).
5. Remove plugs from hydraulic hoses and fittings on
wing deck lift cylinders. Using labels placed during re-
1
moval, correctly attach hydraulic hoses to lift cylinders.
6. Connect cutting deck wire harness to main machine
wire harness (Fig. 5).
7. Position dampers to lift arms. Install clevis pins and
hairpins to secure dampers to lift arms (Fig. 3).
Figure 5
8. Install all removed cutting deck covers.
1. Cutting deck wire harness connection
9. Install hydraulic motors to cutting deck (see Cutting
Deck Motor Installation in the Service and Repairs Sec-
tion of Chapter 4 -- Hydraulic System).
10.Lubricate grease fittings on cutting deck and lift as-
semblies.
11. Fill reservoir with hydraulic fluid as required.
Page 8 - - 8
Cutting Deck Groundsmaster 4100--D/4110--D