Table of Contents
Advertisement
Omni 3210 Installation Guide
Step 5: Connect Optional Device(s)
The Omni 3210 supports the complete line of VeriFone
peripheral devices designed for use with electronic point-of-
sale terminals. For complete information about how to install
and use a peripheral, please refer to the user documentation
supplied with that device.
Using the two RJ-45 type serial ports on the back panel of the
terminal (the RS232 port and the Bar Code/PIN Pad port), you
can connect up to two optional devices to the terminal.
Optional devices available from VeriFone include check
readers, smart card reader/writers, bar code wands, external
PIN pads, and an external printer. Brief descriptions of how to
connect various devices to the Omni 3210 are provided below.
Caution: Before connecting any peripheral device, turn off
power to the terminal. Turn on power only after you are finished
connecting the peripheral device(s).
Connecting an Optional Peripheral to an Omni 3210
Terminal with Attached Swivel Stand
To connect an optional peripheral to an Omni 3210 terminal
with an attached swivel stand, you must:
1.
Remove the swivel stand,
2.
Connect and route the additional serial cable through the
guides in the swivel stand, and
3.
Reattach the swivel stand to the terminal.
Note: The procedure for removing and reattaching the swivel
stand is described in the Omni 3XXX Swivel Stand Quick
Installation Guide (VeriFone Part Number 21919).
18
Advertisement
Table of Contents
