Table of Contents
Advertisement
Note: To connect a Printer 250, a custom interface cable is
required. The specifications for this cable are published in the
Omni 3200/3210 Reference Manual (VeriFone Part Number
22295).
Step 6: Connect the Terminal Power Pack
When you have finished connecting any optional peripheral(s),
you are ready to connect the Omni 3210 to a power source:
Caution: When connecting the terminal to a two-cable power
pack, always connect the three-pronged plug of the power pack
to an electrical wall outlet first. Then insert the round connector
on the end of the other power pack cable into the terminal's
Power port.
1.
Plug the three-pronged plug on the end of one power pack
cable into an electrical power outlet (see Figure 15).
Note: To protect your terminal against possible damage
caused by lightning strikes and electrical surges, you may wish
to install a power surge protector at the power outlet.
2.
Insert the round female type connector on the
end of the other power pack cable into the
Power port on the back of the terminal (see
Figure 15). The Power port is identified by the
icon shown to the right.
Note: The round female type connector on the end of the
power cable is a lock-type device that is designed to prevent
the cable from accidentally being disconnected from the
terminal:
Omni 3210 Installation Guide
23
Advertisement
Table of Contents
