Advertisement
Available languages
Available languages
Engine Run-Time Changing Procedure
1 Cycle ×3
OFF
ACC
1 Cycle
OPEN
CLOSE
1 Answer-back
2 Answer-back
3 Answer-back
2×2 Answer-back
ON
Answer-back
"Pi"
"Pi""Pi"
"Pi""Pi""Pi"
"Pi""Pi"
"Pi""Pi"
- 38 -
• If registration of the Smart Engine Start ID is not
completed, the Smart Engine Start will not operate.
• The Engine Run-time settings must adhere to state,
provincial, and local laws and regulations.
1.
Press the "ENGINE START STOP" Button twice to
switch ignition ON.
2.
Connect the 1P SES Diagnostic Connectors.
3.
Cycle the "ENGINE START STOP" Button from OFF
ACC
IG ON 3 times, and check the number of
answer-back.
* The number of answer-back (simultaneous Hazard Lights
flash and Horn sound) will correspond to the current Engine
Run-Time.
* 1 answer-back
: 3 minutes Engine Run-time
* 2 answer-backs : 5 minutes Engine Run-time
* 3 answer-backs : 10 minutes Engine Run-time
* 2×2 answer-back : 15 minutes Engine Run-time
• The initial Engine Run-Time setting is 15 minutes.
4.
Open and close the Driver's Side Door to change
the Engine Run-time setting.
The Engine Run-time will change as follows depending
on the number of times the Driver's Side Door is
opened and closed (1 Cycle).
* 1 Cycle - 1 answer-back: 3 minutes Engine Run-time
* 2 Cycle - 2 answer-backs: 5 minutes Engine Run-time
* 3 Cycle - 3 answer-backs: 10 minutes Engine Run-time
* 4 Cycle - 2×2 answer-backs: 15 minutes Engine Run-time
* If you perform 5 Cycles or more, the Engine Run-time setting and
answer-back will continually repeat the above 1 to 4 pattern.
• Wait until the answer-back horn stops sounding for
setting to complete before opening the door.
Advertisement
