Installation And Setup; Carriage - Baby Lock Coronet BLCT16A Instruction And Reference Manual

Installation and Setup

Carriage

You should have already set up the Coronet Frame. Refer to the frame manual for detailed instructions
about setting up the frame.
To install the carriage and machine on the frame
1. Place the carriage on the table rails, ensuring
that the stitch regulator faces the back of the
frame.
2. Place the machine on the carriage.
U CAUTION: The Baby Lock Coronet is heavy.
Never attempt to lift it alone. Always use
two people when lifting. Always lift from
the throat of the machine, not from the
handlebars or needle bar.
3. Plug the ribbon cable from the stitch regulator
connector at the back of the machine (see Rear
View on the previous page, #30) into the stitch
regulator on the carriage.
 IMPORTANT: If you ever need to remove the machine from the carriage, disconnect the ribbon
cable from the stitch regulator at the back of the carriage. Failure to unplug the cable when
removing the machine from the carriage could result in damage to the cable, encoders, and
carriage.
 IMPORTANT: The connector is keyed to ensure correct alignment. Make sure the keyed portion of
the cable connector aligns with the keyed portion of the encoder connector. Do not force.
Baby Lock Coronet User Manual
| 13