Installation And Setup; Setting Up The Table (And Taking Down For Storage); Placing Machine In Table - Baby Lock Tiara III BLTR16-3 Instruction And Reference Manual

Installation and Setup

Setting Up the Table (and Taking it Down for Storage)
The Baby Lock Tiara III table has been designed to accommodate the Baby Lock Tiara III machine. It has folding legs
that are height-adjustable and is heavy enough to provide stabilization for quilting at high speeds.
1� Open the box and gently remove the table, taking care not to drop the table on the floor. The table weighs over
50 pounds, so it is recommended that you ask someone for assistance.
2� Remove shipping brace from underneath quilting table by removing the two bolts holding it in place.
3� Unfold the legs by pulling on the horizontal braces, while being careful not to pinch fingers, until the legs snap
into place.
4� Make the table taller by pinching the two height-adjustment tabs on each set of legs and lifting on table, while
holding legs down with your foot. Make the table shorter by pinching the same tabs and pushing down on the
table.
5� To store the table, remove machine and return legs to their lowest position.
6� The legs are attached to the table top with brackets of two different sizes. One is longer than the other. Identify
the long and the short leg brackets.
7� Fold in the short bracket leg first. Push on the horizontal braces to loosen the legs and push them back toward
the table top.
8� Repeat with the long bracket leg.
Placing the Machine in the Table
We recommend having someone help lift and place the machine into the table.
1� Lift the machine by putting one arm through the throat space.
2� Guide the machine from the back of the table into the slot. Machine is positioned correctly when the back of the
machine is flush with the back of the table.
Babylock.com
Page 13