Power Cord; Handlebars And Display - Baby Lock Coronet BLCT16A Instruction And Reference Manual

Power Cord

To install the power cord
• Insert the cord into the power connector on the rear of the machine. Secure the cord with the
metal clip. Plug the three-prong end into power source. Do not turn on the machine until the front
handlebars and display are installed.
To disconnect the power cord
• Unplug the cord from the power outlet. Release the metal clip where the cord connects with the
machine and then pull out the cord.
For more information, see Power Switch in the Using Your Machine section of this manual.
 NOTE: Make sure that the machine is off before plugging into power source. The rear power switch
should be in the 0, or off, position.

Handlebars and Display

U CAUTION: To prevent any electrical damage to the handlebars, always turn off all power to the
machine when connecting or disconnecting the handlebars.
To install the handlebars
1. Ensure that the machine is unplugged from the electrical outlet.
2. Locate the three long button head screws and
the 4 mm Allen wrench. Line up the holes on
top of the handles with the pre-drilled holes on
top of the machine.
3. Slide a single screw into one of the holes until
it stops. Hand tighten the bolt enough to secure
the handles to the top of the machine. Insert
and hand-tighten the remaining two
handlebar bolts.
4. Use the included 4 mm Allen wrench to securely
fasten the handles to the front of the machine.
14 |
www.babylock.com