Optional Accessory: Laser Light Stylus - Baby Lock Coronet BLCT16A Instruction And Reference Manual

Optional Accessory: Laser Light Stylus

The laser light (for use with paper pantographs) attaches to a mounting post with a clamp. The mounting
post attaches to a threaded hole on the thread-path side of the Baby Lock Coronet.
To install the optional laser light stylus
1. Place the nut on the laser light stylus post with
the washer under it and thread the laser post
into the threaded hole, near the rear wheel
base. Turn until securely in place. Lock in place
with nut.
 NOTE: The washer will be under the nut
to protect the machine paint. You can also
mount the laser on an unused spool pin.
2. Insert the laser light stylus into the laser clamp.
3. Slide the laser light clamp over the post to the desired height and ensure it is secure.
4. Plug the laser's cable into the Laser Light Stylus Power Connector (see the Rear View diagram, #31)
on the side of the control pod. When this cable is plugged in, the laser receives power and is turned
on. To turn off the laser, unplug the cable.
The laser projects a straight laser beam visible as a dot on surfaces it hits. Use the laser dot as a guide, or
stylus, to trace printed pantograph designs and stitch the continuous pattern onto a quilt.
The laser light stylus can move in any direction by rotating the clamp on the post and pivoting the laser up
or down. To make an adjustment, loosen the black thumbscrews, position, and retighten.
 IMPORTANT: A label is attached to the laser's case and contains an arrow which indicates the
direction the laser light will shine when energized. The label must remain in place on the laser.
Removing the label voids the laser's warranty.
Baby Lock Coronet User Manual
| 19