Table of Contents
Advertisement
INSTALLATION
02-55
02-50
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1.
Diagram 1
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and
the door lip to ensure that the door sits securely
on the unit. Diagram 2.
Diagram 2
24
02-49
02-51
STANDARD FLUSH DOOR
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring.
diagram 3.
To remove the flush door, reverse the above
steps.
Optional Flush Trim
02-52
02-54
See
Diagram 3
Attach the round
magnets to the
back of the top trim
piece and to the
bottom trim piece,
then attach trim to
the top and bottom
of Flush door.
11) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other). If there is any flame
hesitation, check that area for any blockage
of the burner ports.
12) Install flush glass and bay glass (if used)
as per instructions in this manual.
Flush Louvres
1) Install the top louvre by sliding the two
bracket clips into the brackets located
underneath the top of the firebox.
2) The bottom louvre has a hinge that is
attached (2 screws per hinge) to the lip on
bottom of the unit.
Note: Top and bottom louvres are
different.
Regency
PG36-5 Gas Log Fireplace
®
Advertisement
Table of Contents
