Installing And Configuring Insight Remote Support; Configuring Phone Home Settings - HP StoreAll 8800 Administrator's Manual

Table 1 Hardware support
Product name
StoreAll 9730
IBRIX X9720
StoreAll 9320
StoreAll 9300
StoreAll 8800
StoreAll 8200
1
The MDS600 storage device is not supported by HP IRS. No storage alerts are generated.
2
You may configure the attached storage separately for HP Support. See the storage documentation for more information.
Configuring the StoreAll cluster for Insight Remote Support
The following list is an overview of the steps to perform to configure the StoreAll cluster for HP
Insight Remote Support:
Installing and configuring HP Insight Remote Support

Configuring Phone Home Settings

Compiling the MIB
Configuring entitlements
Discovering devices
IMPORTANT:

Installing and configuring Insight Remote Support

Before installing Insight Remote Support on the CMS, ensure that:
The CMS has external network connectivity.
Wherever the term "CMS" is referenced, enter the IP address of the CMS.
Complete the following steps:
1. Download and install the applicable version of HP Insight Remote Support for the StoreAll OS
version you are running. The product is available from Software Depot:
go/softwaredepot.
2. Open HP IRS in a web browser using the following URL: https://<CMS>:7906.
3. Complete the Hosting Device Setup Wizard.
4. (Optional) Enable email notification. This sends an email notification for the selected Notification
States.
5. Verify the health of HP IRS by selecting Hosting Device Health in the HP IRS user interface.
For more detailed installation steps, locate the installation guide for the applicable HP IRS version
at:
http://www.hp.com/go/insightremotesupport/docs
Configuring Phone Home settings
Configuring Phone Home removes any previous StoreAll snmp configuration details and populates
the SNMP configuration with Phone Home configuration details. When Phone Home is enabled,
you cannot use ibrix_snmpagent to edit or change the snmp agent configuration. However,
you can use ibrix_snmptrap to add trapsink IPs and you can use ibrix_event to associate
events to the trapsink IPs.
20 Getting started
Server
Yes
Yes
Yes
Yes
Yes
Yes
Ensure that all nodes in the cluster are up when completing these steps.
Storage
Yes
1
No
Yes
2
Not supported
Yes
2
Not supported
Chassis
Yes
Yes
Not applicable
Not applicable
Not applicable
Not applicable
http://www.hp.com/