Configuring Dial-In Mgmt; Vantage Cnm; Figure 493 System > Dial-In Mgmt; Table 243 System > Dial-In Mgmt - ZyXEL Communications ZyWALL 1050 User Manual

Internet security appliance

Hide thumbs Also See for ZyWALL 1050:

Table of Contents

Chapter 45 System

45.11.1 Configuring Dial-in Mgmt

Click System > Dial-in Mgmt to display the following screen. Configure this screen for dial-

in management connections.

Figure 493 System > Dial-in Mgmt

The following table describes the labels in this screen.

Table 243 System > Dial-in Mgmt

Dial-in Server

Answer Rings

Initial String

Vantage CNM (Centralized Network Management) is a browser-based global management

solution that allows an administrator from any location to easily configure, manage, monitor

and troubleshoot ZyXEL devices located worldwide. See the Vantage CNM User's Guide for

If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not

do any configurations directly to the ZyWALL (using either the Web Configurator or

commands) without notifying the Vantage CNM administrator.

Click Advanced to display more configuration fields and edit the details of your

dial-in management setup. Click Basic to display fewer fields.

Select this check box to turn on dial-in management.

Enter some information about this connection.

Select this check box to stop the external serial modem from making audible

sounds during a dial-in management session.

Set how many times the ZyWALL lets the incoming dial-in management session

ring before processing it.

Use the drop-down list box to select the speed of the connection between the

ZyWALL's auxiliary port and the external modem. Available speeds are: 9600,

19200, 38400, 57600, or 115200 bps.

Type the AT command string that the ZyWALL returns to the external serial

modem connected to the ZyWALL's auxiliary port during connection initialization.

Note: Consult the manual of your external serial modem

connected to your ZyWALL's auxiliary port for specific AT

Click Apply to save your changes back to the ZyWALL.

Click Reset to begin configuring this screen afresh.

ZyWALL 1050 User's Guide