Zones; Figure 55 Network > Interface > Trunk > Edit > Member; Figure 56 Network > Zone, Initial; Table 33 Zones Example - ZyXEL Communications ZyWALL 1050 User Manual

Internet security appliance

Hide thumbs Also See for ZyWALL 1050:

Table of Contents

Chapter 6 Tutorials

Figure 55 Network > Interface > Trunk > Edit > Member

4 Use the default values for the rest of the settings. Click OK to save these changes and

return to the previous screen.

6.1.4 Zones

This example sets up the LAN, WAN, and DMZ zones as shown below.

Ethernet interface ge2 does not have any physical ports associated with it, so it does not matter

to which zone it is assigned or if it is assigned to any zone at all. The only change you must

make is to remove ge4 from the DMZ zone and add it to the WAN zone. The following steps

accomplish this by removing ge4 from the DMZ zone and changing WAN member ge2 into

ge4, leaving ge2 unassigned to any zone.

1 Click Network > Zone. The following screen appears.

Figure 56 Network > Zone, Initial

2 Click the Edit icon for DMZ, as shown above because you have to remove ge4 from the

DMZ before you can add it to the WAN.

DEFAULT ZONE

ZyWALL 1050 User's Guide