Table of Contents
Advertisement
INSTALLATION
INSPECTION
SHEET
Perform the following inspections.
WARNING
• Before starting the engine, make sure there are no persons in front of or behind the vehicle, or around the engine
compartment. Otherwise a serious accident could result by the vehicle suddenly moving.
• Do not start the engine in a place like a garage or other placer with poor ventilation. Otherwise, poisoning or asphyxation
could result from accumulation of exhaust gas.
• Always set the wheel blocks on level ground before performing the verification.
1.
Inspection items after installation
• Verify the fitting between the vehicle part and the installed part, and inspect for damage or dirt.
2.
Vehicle parts reinstallation
Inspection Parts
Negative battery cable
Ground
Function restore procedure
after removal / Installation
of battery
3.
Installation of accessory, operation check
Inspection Parts
MMS ECU
Mazda CX-3
Mazda2
Inspection Items
Torque check
Are the battery cables securely tightened to the terminals?
Torque check
Is the ground bolt tightened to the proper torque?
Have the vehicle's functions been restored by referring to "Required
Operation
servicing after disconnecting connecting negative battery cable", in
the workshop manual or the owner's manual?
Inspection Items
Has the MMS ECU been registered and checked per Section 9
Registration
(MMS Registration Procedure) and Section 10 (MMS Check Mode)
of the installation instructions?.
Date:
VIN:
Mazda Mobile Start (MMS)
0000-8F-Z80 (MMS ECU Kit)
0000-8F-P07 (MMS Harness Kit)
KD53-V7-629 (Hood Switch)
Inspection
Inspection
24
Check
Check
Check
Hide quick links:
Advertisement
Table of Contents
