Finalizing The Installation - Mazda CX-7 2007 Installation Instructions Manual

22

FINALIZING THE INSTALLATION

1. NOTE: After reassembling the vehicle parts, check for any dirt. Clean any dirty parts.
2. NOTE: After completing the installation, refer to the vehicle Owner's Manual for instructions on how to reset the clock
and preset radio stations.
!
3. CAUTION: Disconnecting the battery causes the DSC indicator light to become inoperable. (The DSC OFF
indicator light flashes and the TCS/DSC indicator light is illuminated.)
Perform the following procedure to restore the DSC to an operable condition:
a. Start the vehicle with the key.
b. Turn the steering wheel completely to the right and then completely to the left.
c. Verify that the DSC OFF indicator light turns off.
d. Turn the ignition switch to the OFF position and then turn it to the ON position again.
e. Verify that the TCS/DSC indicator light turns off.
!
4. CAUTION: When the battery is disconnected, the windows will not fully open and close automatically.
Perform the following procedure to the driver and passenger front windows to resume operation:
a. Turn the ignition switch to the ON position.
b. Press down the window switch on the front passenger's side door panel and fully open the window.
c. Pull up the window switch on the front passenger's side door panel and continue holding for approximately 3
seconds to fully close the window.
d. Press down both front window switches on the driver's door panel and fully open the windows.
e. Pull up both front window switches on the driver's door panel and continue holding for approximately 3 seconds to
fully close the windows.
f. Turn the ignition switch to the OFF position.
21
4280246 Rev. B 11/10