Mms Registration Procedure - Mazda 0000-8F-Z80 Installation Instructions Manual

9. MMS REGISTRATION PROCEDURE

Make sure of the following conditions:
1. In possession of 2 Advanced Keys that are already registered to the vehicle.
2. Do not open any doors during MMS registration procedure.
Steps
1
2X
2
Within
10 Seconds
3
ON
4
5
Connect for
3 Seconds
6
# of LED Flashes
1
3
4
5
6
7
*If LED makes 5 flashes on step 2, refer to table above for 3 flashes.
[After a successful MMS registration, proceed to next section for MMS Check Mode]
MMS Registration Procedure
Connect the negative battery cable and close the hood.
Enter vehicle's passenger side and close the door.
• MMS Harness LED lights up, wait 30 seconds until the LED light
turns off
Connect and disconnect the RES Diagnostic Connectors twice
within 10 seconds.
• MMS Harness LED makes 2 flashes.*
If the MMS Harness LED did not flash, this procedure has failed.
• Disconnect the battery and start over from step 1.
Hold up the Advanced Key over the Start Button switch, then
press the Start Button with the Advanced Key twice to the ON
position.
• Security indicator turns ON for 3 seconds, then turns off
I f Security indicator does not turn ON, this procedure has failed.
• Disconnect the battery and start over from step 1.
Within 4 seconds of the security indicator turning off, press the
Start Button with the Advanced Key to the OFF position.
• The Security indicator flashes.
If Security indicator does not flash, this procedure has failed.
• Disconnect the battery and start over from step 1.
Repeat steps 3 and 4 for the 2nd Advanced Key.
After both Advanced keys have been authenticated, connect the
RES Diagnostic Connectors for at least 3 seconds then disconnect.
Observe the number of flashes from the MMS Harness LED.
• MMS Harness LED flash 2 times and Start Button light will turn
ON automatically for a few seconds then shuts off, indicating a
successful registration. Proceed to next section MMS Check Mode.
If this procedure failed, the ignition switch stays OFF. Look at the
table below to determine the cause of failed registration.
• Check and fix the cause of failed registration.
• Disconnect the battery and start over from step 1.
Cause of Failed Registration
Missed operation or step
3 or more MMS ECU's have already been registered to the vehicle
Vehicle condition is not satisfied or MMS ECU is already registered (proceed to MMS Check Mode)
Time limit have elapsed
Advanced Keys are not registered.
Communication error between MMS and SSU.
21
Response
Response
when
when it fails
successful
2X
Security Indicator
ON for 3 Seconds
OFF
OFF
Security Indicator
OFF
Flashing
2X
1,3,4,5,6,7