Vehicles With Protective Pad On Glove Box Undercover - Mazda 0000-8F-Z80 Installation Instructions Manual

3 x Double-sided
adhesive tapes
(25 x 25 mm)
ALIGNMENT
Double-sided
Adhesive tape
(25 x 69mm)

Vehicles with protective pad on glove box undercover

Protective Pad
(Steps 42 to 50)
42. Peel off part of the protective pad and clean off adhesive
residue from the glove box undercover.
• Use 3M Promoter-4298 for primer.
• When degreasing using primer, only apply primer to indicated
area to prevent other parts from becoming discolored.
• After degreasing using primer, let it dry for 1 min. or more.
43. Degrease the indicated areas of Glove Box under cover
using primer.
44. Apply 3 Double-sided adhesive tapes (25 x 25 mm) to the
Glove Box under cover on 3 indicated locations.
45. Degrease the bottom side of the MMS ECU using primer.
46. Place the MMS ECU on Glove Box undercover as shown
and ensure Double-sided adhesive tape secures MMS
ECU to the Glove Box undercover.
Note
• Ensure ECU is properly aligned as shown.
• Ensure MMS ECU harness connector, GSM and TEL
connectors are plugged into the MMS ECU before attaching
to the Glove Box under cover.
47. Apply the Double-sided adhesive tape (25 x 69mm) on the
Protective Pad
MMS ECU as indicated.
48. Reapply the protective cover over the MMS ECU securing
it with the Double-sided tape.
49. Cut 1 Urethane foam tape into 2/3 size.
50. Apply 1 and the 2/3 sized Urethane Foam tapes to secure
the MMS Harness, GPS and TEL cables on the Glove Box
1 Urethane
Foam tape
under cover.
2/3 Urethane
Foam tape
19
Caution
Caution