Testing An Uninitialized Key - AT&T DEFINITY Remote Port Security Device User Manual

Power-Up Behavior of Uninitialized Key
With an uninitialized Key, the left four LEDs will all light up upon power-up. If any other
behavior occurs, there is a firmware error and the Key should be replaced.

Testing an Uninitialized Key

Test an RPSD Key that has not been initialized by connecting either a telephone or a terminal to
the port on the back panel of the Key, then dial the associated RPSD Lock, either
Subscriber
directly via the telephone or via an application on the terminal. If the connection is good, the
yellow Verify light comes on frost, followed by the green Connection light. This should occur in
less than 30 seconds. The connection light will remain lit until the call is ended. If the
connection fails, the red Idle light comes on.
2-22 Installation