AT&T Definity 8101 Quick Reference Manual

AT&T
®
DEFINITY Communications System
Generic 1 and Generic 3 and System 75
and Generic 2 and System 85
8101, 8102, and 8110 Telephones
Quick Reference Guide
AT&T 555-230-773
Comcode 107163735
Refer to the procedures on this card to use system
features on your 8101, 8102, or 8110 telephones.
These features are listed in alphabetical order. For
more information, see your system manager or refer to
®
the DEFINITY Communications System Generic 1
and Generic 3 and System 75 and Generic 2 and
System 85 8101, 8102, and 8110 Telephones User's
Guide, 555-204-746.
ABBREVIATED DIALING
Note: Both the 8102 and the 8110 telephones have
12 programmable dialing buttons on which you can
store telephone numbers or access codes. In
addition, DEFINITY Generic 1 and System 75 allow
you to store numbers in a maximum of three
Abbreviated Dialing lists.
To program or reprogram an outside number,
extension, or feature code into a personal list
1
On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you
want to program as items on your personal list(s)
2
Pick up handset [dial tone]
3
Dial Abbreviated Dialing Program
code [dial tone]
4
Dial personal list number (1, 2, or 3)
Version Note: If you are using System 75,
Version 1, you may omit Step 4.
5
Dial list item (1,2, 3...) [dial tone]
6
Dial the number you want to program
[ ]
1
Version Note: If you are using System 75,
Version 1, you can use up to 16 digits; for
Version 2, you can use up to 24 digits.
Note: If you are programming an outside number,
be sure to include a trunk code, if applicable.
7 Press [ # ]
Number is stored
Repeat Steps 5 through 7 if you want to
program additional items on the same list;
hang up and begin again at Step 1 if you want
to program items on another personal list
8 Hang up to end programming
To place a call using a personal, group, system, or
enhanced list
1 Dial appropriate Abbreviated Dialing List code:
List 1
List 2
List 3
2 Dial desired list item (1,2, 3...)
Stored number is automatically dialed
AUTOMATIC CALLBACK
To automatically place another call to an extension
that was busy or did not answer
Press [ FLASH ] during call attempt [recall dial tone]
1
2 Dial the Automatic Callback code
[confirmation tone]
3 Hang up
You will receive a 3-burst priority ring when the
extension you attempted to call is available
Note: After you activate Automatic Callback, the
system monitors the called extension. That
extension becomes available after the called party
completes a call.
4 Lift the handset when you hear priority ring
[ringback tone]
A call is automatically placed to extension,
which receives regular ringing
[dial tone]
[ ]
2