AT&T DEFINITY Remote Port Security Device User Manual page 92

Code
Message
No.
4
Blocked User
5
Invalid
Response
6
Outgoing Call
7
Ring - No
Answer
8
Force
Disconnect
TABLE 5-1 (Continued)
Access Failure Messages
Meaning
No action necessary. This is a deliberate
The
Block command issued by the administrator.
administrator
placed a block
on the caller's
RSPD Key user
ID.
Check the Test Responses to make sure the
The RSPD Key
RSPD Lock and RSPD Key Test Responses
responded to
match (see Chapters 3 and 4 for checking
the RSPD
Test Responses). If access for this Key is
Lock's
desired, and the Test Responses do not
challenge, but
match, you will need to use the Wipe Out
the response
command (see Chapter 4, RSPD Key Use) to
was incorrect.
return the Key to a virgin state. Then follow
the directions for initializing the RSPD Key,
also found in Chapter 4.
No action necessary.
An outgoing
This is not a call failure.
call is being
placed. If a call
is connected,
the Lock forces
a disconnect in
order to make
the outgoing
call.
Run the Modem Ring Test described in this
The RSPD
chapter and follow the directions for
Lock rang the
determining the cause of failure.
modem, but the
modem did not
pick up.
No action necessary. This is a
A Force
deliberate disconnect command
Disconnect
issued by the administrator.
command was
issued to the
RSPD Lock.
Action
Access Failure Messages
5-5